WM1x19 (f), WM1x19 (r), with identical hubs (from 350cc) and black rims. Bolt on rear sprocket.
5” D section, unvalanced front and rear. Rear with detachable tail section.
Petrol/oil tank finished in black and gold. Twin external screw fillers (oil & petrol) with front fitted petrol balance pipe. Single bolt damper arm fixing but no damper fitted.
2 valve twin port overhead or single port side valve J.A.P. with rear mounted ML Maglita or round ML magneto. External Best and Lloyd oil pump.
Both 6 3/4”, coupled with steel shoes. (early models had hubs with the brake drums on the left, rear with bolt on sprocket and cross over brake pedal – non of these models are known to have survived).
Miller 6” 64EA headlamp (with small ammeter retained by 3 screws), rear mounted switch and 34E rear lamp.
4 speed Rudge gearbox with hand change on RHS of tank. External kickstarter stop. Pressed steel primary cover.
Amac 30 PJY # with 2 lever control.
Twin 1 3/4” or single 1 1/2” low level pipes into Rudge ‘can’ type silencer(s) and 6” fishtail(s).
Non adjustable 1” handlebars with folded type inverted levers. Single toolbox mounted opposite battery carrier on nearside of machine. Riveted angle and strip steel centre stand. Open ended ‘D’ section forks.
Twist grip control to carburetter.
New RudgeSpares - Forum - Technical Drawings - Archive information - Library books - Spares lists - Technical advice
Become part of this active and supportive Club today! From only £21 you can join us and the fantastic support offered as a Member.